The final element of the myhairdirect™ do-it-yourself program is cleaning.

Cleaning your scalp

Follow these instructions to effectively remove adhesive and/or tape residue from your scalp.

Items Required:

• C22 Citrus Remover
• Kitchen roll
• Shampoo

Instructions

1. Spray C22 onto your scalp and allow to penetrate for 1-2 minutes.
2. Firmly wipe of adhesive residue with kitchen roll (useful because of its abrasive surface) until any trace of adhesive has been completely removed.
3. Shampoo your scalp and hair to remove any trace of adhesive remover, then rinse thoroughly. It is necessary to repeat this step approx. 4 or 5 times because any trace of adhesive remover will weaken and break down future bonding.

Cleaning your system

Removing Adhesive Residue - Second Skin™ and Gel Flex™ (no lace front)

It is essential to also remove any adhesive and/or tape residue from your system to guarantee the efficacy of your bonding.

Items Required:

• C22 Citrus Remover
• Kitchen roll
• Shampoo

Instructions

1. Spray C22 onto the underside your system and allow to penetrate for 1-2 minutes.
2. Firmly wipe of adhesive residue with kitchen roll (useful because of its abrasive surface) until any trace of adhesive has been completely removed.
3. Shampoo the underside of your system to remove any trace of adhesive remover, then rinse thoroughly. It is necessary to repeat this step approx. 4 or 5 times because any trace of adhesive remover will weaken and break down future bonding.

Removing Adhesive Residue - Invisible™ and systems with lace frontals

If you are using the Invisible™ or your system incorporates a lace front, please follow the lace cleaning instruction below.

Items Required:

• MHD Remove™
• 1ft sq Mirror Tile (available in DIY stores)
• Cotton Wool

Instructions

1. Gently press the bottom of the lace (area to be cleaned) onto the upper section of the mirror.
2. Now gently slide the system towards you, over the entire length of the mirror. You should now notice the adhesive residue has collected on the mirror.
3. Clean the adhesive residue off the mirror using MHD Remove™ and Cotton Wool.
4. Repeat this process until the entire lace is clean.

Removing Tape

1. Using your fingers, lift a corner of the tape up and gently peel the tape off the system.

Tip

1. If the tape is difficult to peel off, spray a fine mist of C22 onto the tape to ease removal.

If there is any tape residue remaining on the system, please follow the cleaning instructions above.